MIRAGE DINER
SCORE: 84 POINTSWednesday, November 26, 2025
MIRAGE DINER in Gravesend (East) Homecrest underwent a NYC health inspection on November 26, 2025 and scored 84 points. The inspection found 7 violations, including 7 critical.
Violations Cited
02B
Hot TCS Food Not Held at 140°F or Above
Hot TCS food item not held at or above 140 °F.
BACTERIAL MULTIPLICATION: At 120°F, Clostridium perfringens doubles every 10 minutes. Can reach illness-causing levels within 1 hour. This bacteria causes 1 million US cases annually with severe abdominal cramps and diarrhea lasting 24 hours. Hot holding violations responsible for 40% of restaurant outbreaks.
Maintain ALL hot foods at 140°F minimum. Check temperatures every 30 minutes for problem foods, every 2 hours otherwise. Use calibrated thermometers. Adjust equipment immediately if below 140°F. Reheat to 165°F if below temp for under 2 hours. DISCARD if below 140°F for over 2 hours.
02G
Cold TCS Food Held Above 41°F
Cold TCS food item held above 41 °F; smoked or processed fish held above 38 °F; intact raw eggs held above 45 °F; or reduced oxygen packaged (ROP) TCS foods held above required temperatures except during active necessary preparation.
DANGER ZONE GROWTH: Between 41-70°F, E. coli doubles every 30 minutes. Salmonella doubles every 20 minutes at 70-90°F. After just 4 hours above 41°F, bacteria levels can cause severe illness including bloody diarrhea, kidney failure (E. coli), and typhoid fever (Salmonella).
Keep all cold TCS foods at 41°F or below (smoked fish 38°F, shell eggs 45°F). Monitor with calibrated thermometer every 2-4 hours. Ice baths must surround container to food level. Repair refrigeration immediately. DISCARD foods above 41°F for over 4 hours.
06D
Food Contact Surfaces Not Properly Sanitized
Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.
BACTERIAL BUILDUP: Unsanitized surfaces harbor millions of bacteria within hours. Cross-contamination affects all food prepared on surface. Major cause of multi-victim outbreaks. Cutting boards can contain 200x more bacteria than toilet seats.
Clean and sanitize ALL food contact surfaces: After each use, Between different food types, Every 4 hours in continuous use, When contaminated. Use proper concentration sanitizer (50-100ppm chlorine, 200-400ppm quat). Air dry. Test sanitizer every 2 hours.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
05A
NYC Health Code Violation 05A
Sewage disposal system is not provided, improper, inadequate or unapproved.
HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link NYC Health Code Violation 05A to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
Follow NYC Health Code Article 81 requirements. Implement corrective action immediately. Document all corrections. Train staff on proper procedures. Schedule follow-up inspection if critical.
04F
NYC Health Code Violation 04F
Food preparation area, food storage area, or other area used by employees or patrons, contaminated by sewage or liquid waste.
HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link NYC Health Code Violation 04F to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
Follow NYC Health Code Article 81 requirements. Implement corrective action immediately. Document all corrections. Train staff on proper procedures. Schedule follow-up inspection if critical.
10G
Dishwashing facilities inadequate
Dishwashing and ware washing: Cleaning and sanitizing of tableware, including dishes, utensils, and equipment deficient.
Inadequate dishwashing spreads bacteria across all utensils and tableware
Three-compartment sink or approved dishwasher; proper wash, rinse, sanitize procedures
Violations were cited in the following area(s).
MIRAGE DINER — Inspection Questions
- Did MIRAGE DINER pass their NYC health inspection on November 26, 2025?
- MIRAGE DINER underwent inspection on November 26, 2025 with a score of 84 points. The inspection found 7 violation(s).
- What critical violations did MIRAGE DINER have?
- MIRAGE DINER had 7 critical violation(s) during their inspection. Critical violations directly contribute to foodborne illness and must be corrected immediately. These include issues with temperature control, hand washing, cross-contamination, and pest infestations.
- What does violation code 02B mean in NYC restaurant inspections?
- NYC violation 02B (Hot TCS Food Not Held at 140°F or Above) is a critical violation. Hot potentially hazardous foods must be maintained at 140°F or above to prevent rapid bacterial growth in the danger zone (41-140°F). BACTERIAL MULTIPLICATION: At 120°F, Clostridium perfringens doubles every 10 minutes. Can reach illness-causing levels within 1 hour. This bacteria causes 1 million US cases annually with severe abdominal cramps and diarrhea lasting 24 hours. Hot holding violations responsible for 40% of restaurant outbreaks.
- What does violation code 02G mean in NYC restaurant inspections?
- NYC violation 02G (Cold TCS Food Held Above 41°F) is a critical violation. Cold potentially hazardous foods must be kept at 41°F or below (38°F for smoked fish) to prevent bacterial growth. DANGER ZONE GROWTH: Between 41-70°F, E. coli doubles every 30 minutes. Salmonella doubles every 20 minutes at 70-90°F. After just 4 hours above 41°F, bacteria levels can cause severe illness including bloody diarrhea, kidney failure (E. coli), and typhoid fever (Salmonella).
- What does violation code 06D mean in NYC restaurant inspections?
- NYC violation 06D (Food Contact Surfaces Not Properly Sanitized) is a critical violation. Food contact surfaces not washed, rinsed, and sanitized after each use and following contamination. BACTERIAL BUILDUP: Unsanitized surfaces harbor millions of bacteria within hours. Cross-contamination affects all food prepared on surface. Major cause of multi-victim outbreaks. Cutting boards can contain 200x more bacteria than toilet seats.
- What does violation code 10F mean in NYC restaurant inspections?
- NYC violation 10F (Non-food Contact Surfaces Not Clean) is a minor violation. Non-food contact surfaces or equipment not kept clean, not properly sealed, or not properly maintained. INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
- What does violation code 05A mean in NYC restaurant inspections?
- NYC violation 05A (NYC Health Code Violation 05A) is a critical violation. Violation of NYC Health Code requirements HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link NYC Health Code Violation 05A to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
- What does violation code 04F mean in NYC restaurant inspections?
- NYC violation 04F (NYC Health Code Violation 04F) is a critical violation. Violation of NYC Health Code requirements HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link NYC Health Code Violation 04F to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
- What does violation code 10G mean in NYC restaurant inspections?
- NYC violation 10G (Dishwashing facilities inadequate) is a major violation. Proper warewashing facilities and procedures required to sanitize equipment Inadequate dishwashing spreads bacteria across all utensils and tableware