MEAL MART
SCORE: 27 POINTSWednesday, May 21, 2025
Violations Cited
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
06C
Food not protected from contamination
Food, supplies, or equipment not protected from potential source of contamination during storage, preparation, transportation, display, service or from customer’s refillable, reusable container. Condiments not in single-service containers or dispensed directly by the vendor.
Unprotected food exposed to bacteria, viruses, chemicals, and physical contaminants
Cover all food; store 6 inches off floor; protect from customer contamination; use sneeze guards
02B
Hot TCS Food Not Held at 140°F or Above
Hot TCS food item not held at or above 140 °F.
BACTERIAL MULTIPLICATION: At 120°F, Clostridium perfringens doubles every 10 minutes. Can reach illness-causing levels within 1 hour. This bacteria causes 1 million US cases annually with severe abdominal cramps and diarrhea lasting 24 hours. Hot holding violations responsible for 40% of restaurant outbreaks.
Maintain ALL hot foods at 140°F minimum. Check temperatures every 30 minutes for problem foods, every 2 hours otherwise. Use calibrated thermometers. Adjust equipment immediately if below 140°F. Reheat to 165°F if below temp for under 2 hours. DISCARD if below 140°F for over 2 hours.
04H
Food Contaminated or Cross-Contaminated
Raw, cooked or prepared food is adulterated, contaminated, cross-contaminated, or not discarded in accordance with HACCP plan.
PATHOGEN SPREAD: Cross-contamination spreads deadly bacteria throughout facility. One contaminated cutting board can transfer Salmonella to 20+ food items. Causes multi-victim outbreaks. E. coli O157:H7 from raw beef can cause kidney failure in children.
Prevent ALL cross-contamination: Separate equipment for raw and ready-to-eat, Color-coded cutting boards, Proper storage order (raw below ready-to-eat), Clean and sanitize between different foods, Cover all foods, Change gloves between tasks.
09B
Thawing procedure improper
Thawing procedure improper.
Improper thawing allows surface bacteria to multiply while interior remains frozen
Thaw under refrigeration, under cold running water, in microwave, or as part of cooking
10B
Plumbing Not Properly Installed or Maintained
Anti-siphonage or back-flow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly. Condensation or liquid waste improperly disposed of.
WATER CONTAMINATION: Backflow can siphon sewage into water supply, contaminating entire facility. Cross-connections spread pathogens throughout plumbing. Sewage backups create immediate health hazard. Can affect hundreds through contaminated water.
Install backflow preventers on ALL required fixtures. Maintain air gaps (2x pipe diameter minimum). Fix all leaks immediately. Ensure proper drainage - no standing water. Regular plumbing inspection. No direct connections between sewage and water supply.
Violations were cited in the following area(s).