J & J PIZZA
SCORE: 23 POINTSWednesday, June 4, 2025
Violations Cited
08A
Facility Not Free from Harborage Conditions
Establishment is not free of harborage or conditions conducive to rodents, insects or other pests.
PEST ATTRACTION: Harborage conditions support pest infestations. Gaps allow entry of rodents carrying 35+ diseases. Standing water breeds flies that spread 100+ pathogens. Clutter provides nesting for pests. Creates ongoing contamination risk.
Eliminate ALL harborage conditions: Seal cracks/holes (1/4 inch for mice, 1/2 inch for rats), Fix leaking pipes, Remove clutter/unused equipment, Eliminate standing water, Clean grease accumulation, Maintain 6 inches clearance from walls, Remove cardboard storage.
04K
Evidence of Rats Present in Facility
Evidence of rats or live rats in establishment's food or non-food areas.
SEVERE BIOHAZARD: Rats carry 35+ diseases including Leptospirosis (kidney/liver failure), Hantavirus (38% mortality), Salmonella, and plague. One rat produces 40-50 droppings daily containing millions of pathogens. Urine aerosols spread disease throughout facility.
IMMEDIATE ACTION REQUIRED: Close affected areas, Professional extermination within 24 hours, Clean/sanitize with 10% bleach solution, Discard ALL contaminated food, Seal holes over 1/2 inch, Remove food/water sources, Install bait stations, May require closure.
02B
Hot TCS Food Not Held at 140°F or Above
Hot TCS food item not held at or above 140 °F.
BACTERIAL MULTIPLICATION: At 120°F, Clostridium perfringens doubles every 10 minutes. Can reach illness-causing levels within 1 hour. This bacteria causes 1 million US cases annually with severe abdominal cramps and diarrhea lasting 24 hours. Hot holding violations responsible for 40% of restaurant outbreaks.
Maintain ALL hot foods at 140°F minimum. Check temperatures every 30 minutes for problem foods, every 2 hours otherwise. Use calibrated thermometers. Adjust equipment immediately if below 140°F. Reheat to 165°F if below temp for under 2 hours. DISCARD if below 140°F for over 2 hours.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
Violations were cited in the following area(s).