BUCCANEER DINER
SCORE: 0 POINTSFriday, May 27, 2022
Violations Cited
10B
Plumbing Not Properly Installed or Maintained
Plumbing not properly installed or maintained; anti-siphonage or backflow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly.
WATER CONTAMINATION: Backflow can siphon sewage into water supply, contaminating entire facility. Cross-connections spread pathogens throughout plumbing. Sewage backups create immediate health hazard. Can affect hundreds through contaminated water.
Install backflow preventers on ALL required fixtures. Maintain air gaps (2x pipe diameter minimum). Fix all leaks immediately. Ensure proper drainage - no standing water. Regular plumbing inspection. No direct connections between sewage and water supply.
05D
Hand Washing Facility Not Properly Equipped
Hand washing facility not provided in or near food preparation area and toilet room. Hot and cold running water at adequate pressure to enable cleanliness of employees not provided at facility. Soap and an acceptable hand-drying device not provided.
HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link Hand Washing Facility Not Properly Equip to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
Provide immediately at ALL handwash sinks: Hot water (100-120°F), Soap in dispensers, Paper towels or air dryers, Trash receptacles, Signage, Keep accessible at all times. Check supplies hourly. Assign staff to monitor and restock.
06D
Food Contact Surfaces Not Properly Sanitized
Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.
BACTERIAL BUILDUP: Unsanitized surfaces harbor millions of bacteria within hours. Cross-contamination affects all food prepared on surface. Major cause of multi-victim outbreaks. Cutting boards can contain 200x more bacteria than toilet seats.
Clean and sanitize ALL food contact surfaces: After each use, Between different food types, Every 4 hours in continuous use, When contaminated. Use proper concentration sanitizer (50-100ppm chlorine, 200-400ppm quat). Air dry. Test sanitizer every 2 hours.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface improperly constructed. Unacceptable material used. Non-food contact surface or equipment improperly maintained and/or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
06C
Food not protected from contamination
Food not protected from potential source of contamination during storage, preparation, transportation, display or service.
Unprotected food exposed to bacteria, viruses, chemicals, and physical contaminants
Cover all food; store 6 inches off floor; protect from customer contamination; use sneeze guards
09C
Food contact surface improperly constructed
Food contact surface not properly maintained.
Improper surfaces harbor bacteria in cracks and cannot be properly sanitized
Use stainless steel, approved plastics; no wood except cutting boards; smooth, intact surfaces
Violations were cited in the following area(s).