WOK WOK RESTAURANT
SCORE: 0 POINTSTuesday, June 7, 2022
Violations Cited
05D
Hand Washing Facility Not Properly Equipped
Hand washing facility not provided in or near food preparation area and toilet room. Hot and cold running water at adequate pressure to enable cleanliness of employees not provided at facility. Soap and an acceptable hand-drying device not provided.
HEALTH HAZARD: This critical violation creates immediate risk of foodborne illness. Studies link Hand Washing Facility Not Properly Equip to bacterial contamination and outbreak events. Must be corrected immediately to protect public health.
Provide immediately at ALL handwash sinks: Hot water (100-120°F), Soap in dispensers, Paper towels or air dryers, Trash receptacles, Signage, Keep accessible at all times. Check supplies hourly. Assign staff to monitor and restock.
02H
Food Not Cooled by Approved Method
Food not cooled by an approved method whereby the internal product temperature is reduced from 140º F to 70º F or less within 2 hours, and from 70º F to 41º F or less within 4 additional hours.
TOXIN PRODUCTION: Slow cooling is the #1 cause of foodborne outbreaks. Clostridium perfringens spores survive cooking and germinate during slow cooling, producing heat-stable toxin. Causes 'buffet illness' affecting hundreds at events. Staph aureus produces toxin that CANNOT be destroyed by reheating.
Cool using approved methods: Shallow pans (2 inches max depth), Ice baths with frequent stirring, Ice paddles, Blast chillers, Cut large items into portions. NEVER cool at room temperature. NEVER stack hot containers. Document cooling times and temperatures.
02B
Hot TCS Food Not Held at 140°F or Above
Hot food item not held at or above 140º F.
BACTERIAL MULTIPLICATION: At 120°F, Clostridium perfringens doubles every 10 minutes. Can reach illness-causing levels within 1 hour. This bacteria causes 1 million US cases annually with severe abdominal cramps and diarrhea lasting 24 hours. Hot holding violations responsible for 40% of restaurant outbreaks.
Maintain ALL hot foods at 140°F minimum. Check temperatures every 30 minutes for problem foods, every 2 hours otherwise. Use calibrated thermometers. Adjust equipment immediately if below 140°F. Reheat to 165°F if below temp for under 2 hours. DISCARD if below 140°F for over 2 hours.
08A
Facility Not Free from Harborage Conditions
Facility not vermin proof. Harborage or conditions conducive to attracting vermin to the premises and/or allowing vermin to exist.
PEST ATTRACTION: Harborage conditions support pest infestations. Gaps allow entry of rodents carrying 35+ diseases. Standing water breeds flies that spread 100+ pathogens. Clutter provides nesting for pests. Creates ongoing contamination risk.
Eliminate ALL harborage conditions: Seal cracks/holes (1/4 inch for mice, 1/2 inch for rats), Fix leaking pipes, Remove clutter/unused equipment, Eliminate standing water, Clean grease accumulation, Maintain 6 inches clearance from walls, Remove cardboard storage.
06A
Personal cleanliness inadequate
Personal cleanliness inadequate. Outer garment soiled with possible contaminant. Effective hair restraint not worn in an area where food is prepared.
Poor hygiene transfers pathogens; contaminated clothing spreads bacteria throughout facility
Clean outer garments; hair restraints; no jewelry; short, clean fingernails; no nail polish
02G
Cold TCS Food Held Above 41°F
Cold food item held above 41º F (smoked fish and reduced oxygen packaged foods above 38 ºF) except during necessary preparation.
DANGER ZONE GROWTH: Between 41-70°F, E. coli doubles every 30 minutes. Salmonella doubles every 20 minutes at 70-90°F. After just 4 hours above 41°F, bacteria levels can cause severe illness including bloody diarrhea, kidney failure (E. coli), and typhoid fever (Salmonella).
Keep all cold TCS foods at 41°F or below (smoked fish 38°F, shell eggs 45°F). Monitor with calibrated thermometer every 2-4 hours. Ice baths must surround container to food level. Repair refrigeration immediately. DISCARD foods above 41°F for over 4 hours.
10F
Non-food Contact Surfaces Not Clean
Non-food contact surface improperly constructed. Unacceptable material used. Non-food contact surface or equipment improperly maintained and/or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.
INDIRECT CONTAMINATION: Dirty non-food surfaces harbor pests and bacteria. Employees touch these surfaces then food. Accumulation attracts roaches and rodents. Creates reservoir of contamination that spreads throughout facility.
Clean all non-food surfaces regularly: Walls, ceilings, floors daily in food areas, Equipment exteriors, Storage shelves, Light fixtures monthly. Seal cracks. Repair damaged surfaces. Maintain cleaning schedule. Assign responsibilities.
04N
Filth Flies Present in Food Areas
Filth flies or food/refuse/sewage-associated (FRSA) flies present in facility’s food and/or non-food areas. Filth flies include house flies, little house flies, blow flies, bottle flies and flesh flies. Food/refuse/sewage-associated flies include fruit flies, drain flies and Phorid flies.
RAPID CONTAMINATION: Flies carry 100+ pathogens on feet and bodies. One fly transfers 2 million bacteria per landing. Feed by vomiting on food. Can contaminate entire prep area in minutes. Major vector for E. coli, Salmonella, Shigella transmission.
Eliminate breeding sites: Clean drains daily, Remove standing water, Empty garbage frequently, Install air curtains/screens, Use fly lights away from food, Clean up spills immediately, Locate and eliminate larval breeding sites (drains, garbage, produce).
06D
Food Contact Surfaces Not Properly Sanitized
Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.
BACTERIAL BUILDUP: Unsanitized surfaces harbor millions of bacteria within hours. Cross-contamination affects all food prepared on surface. Major cause of multi-victim outbreaks. Cutting boards can contain 200x more bacteria than toilet seats.
Clean and sanitize ALL food contact surfaces: After each use, Between different food types, Every 4 hours in continuous use, When contaminated. Use proper concentration sanitizer (50-100ppm chlorine, 200-400ppm quat). Air dry. Test sanitizer every 2 hours.
Violations were cited in the following area(s).